Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between diode and zener diode?
- 4 Answers
- 8062 Views
- I also Faced
- E-Mail Answers
Answer Posted / shahulsnfa
diode conducts only in forward bias.the diode will break
down when it is revrse biased. but zener will conduct in
reverse bias also. break down will occur after some voltage
level which is more compare to diode
| Is This Answer Correct ? | 20 Yes | 0 No |
Post New Answer View All Answers
what is the Transformer Impedence?How can calculate?
Dear sir, In our plant have Station Transformer having capacity,i want to know, why LV side 40 - 40MVA is given? & how we can get 6.3 KV supply from tertiary(i.e. Open delta connection), Vector Group YNyn0 - yn0 +d MVA Rating 80MVA / 40 - 40MVA + 26.7MVA Voltage rating 420 (Tap range +6,to -10)81.25% /11.5KV - 11.5KV +6.3KV
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
what is the generator rating for 40 amp load of 3phase motor.?? 400v voltage of generator... plz tell me with formula its urgent...plzzz... and also tell me that this 40 amp at all phases mean 40 amp on red,40 amp on yellow,40 amp on blue...... or the total sum of that 3phase is 40 amp....
How to synchronization will be done between two DGs ?
What types of question are done for diploma students in aptitude test
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
On what principle electric motor works?
what's producer of XLPE cable laying in undergroung
Enlists the applications of sampled data systems?
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?
CAN ANYBODY PLEASE TELL ME HOW TO DESIGN A SERIES REACTOR FOR LIMITING SHORT CIRCUIT FAULT CURRENT??
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
if i am in front of transmission line how to know that current direction without any equipment
