Interested to Buy Any Domain ? << Click Here >> for more details...
where we use stardelta starter and dol starter
- 4 Answers
- 16862 Views
- HCL, I also Faced
- E-Mail Answers
Answer Posted / kumar
both are use in motor ,The purpose of stardelta starter is
to limit the starting current of motor.If the starting
current is low means we can use dol starter upto 5 hp
motor.above 5 hp motor we should use stardelta starter for
limit the starting current.
| Is This Answer Correct ? | 43 Yes | 4 No |
Post New Answer View All Answers
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
What is the emf equation of a transformer?
From what on-site components does the HT panel monitoring the bus-bars in a 11kV system take inputs?
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
what is the meaning of the symbol << >> put in transformer drawing
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
what is the difference b/w ground & virtual ground?
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
What will happen to the protection and metering, if the polarity of a single or two PT/PTs in three phase system is reversed? Please provide reference if any.
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
What are the parameters of water ( Water quality )to be monitored in Centralised HVAC ( water cooler chillers )
please send me RRB electrical engineer previous year questions for Sr. Section Engineer
Explain cos(theta) and Sin(theta)
kVA rating of ordinary transformer is increased when connected as an auto transformer because A transformation ratio increased B secondary voltage increased C energy is transferred both inductively and conductively D secondary current increased
