Interested to Buy Any Domain ? << Click Here >> for more details...
Can any body give detail about orifice sizing?
- 5 Answers
- 10561 Views
- Essar, I also Faced
- E-Mail Answers
Answer Posted / pasuvaraj
beta ratio 0.4 to 0.65, this gives the perment pressure
drop across the orifice, internal bore of orifice plate
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?
Boolean algebra
How can i test procedure grounding for CAT-7 cable? Or How can we test procedure CAT-7 Cable Electrically safe?
in mass flow meter what is drive friquancy ?
What is the PLC configuration in Cement industry?
what is the importance of CV in the control valves? how it is calculated?
how do we commission inergen system?
Exothermic reaction./ endothermic reaction
why is an oxygen sensor used in a boiler stack
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
types of cable..? Use of every types of cable..?
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
