Answer Posted / pasuvaraj
To increase the power factor & reduce the Harmonics
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How does temperature bath work? How does coil gets heated only by applying some current?
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
how to measure oxygen which methods are using?
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
how we are selecting instuments by differentiating certain instruments in 4 to 20 ma range and certain in 1 to 5 v dc
field bus transmitter calibration procedure tell me
I want to buy a seal kit of a pneumatic power cylinder.But I don't know it's specification.So please help me to know its specification.
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
I need control valve ISA hand book. Is there any site to download that big book containing all the pages. Written by Paul Friedmann
What is difference between radial vibration and axial vibration explain in detail .
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
what is isloted barrier how it works and what are the main purpose.how it make safe area.
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
What is feed factor and its Importance in cement industry? How we can solve feed factor?.