Kinetic friction when compared to Static friction is?
- 8 Answers
- 10154 Views
- HAL, I also Faced
- E-Mail Answers
Answer Posted / vaneshwar sahu
static friction depends upon applied force, whereas kinetic friction is a constant force when body is in motion. static friction varies from zero to limiting friction,which is greater than kinetic friction,thus we can say that,static friction can be more or less than kinetic friction depending upon force applied,
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
HOW TO calculate steam velocity on boiler o/l ?
why coposite materials are sronger than solids
please sent last five years junior engineer mechnical question pappers
whats the coloring code of a air to open or a air to close valve?
you did b.tech why u r intrested marketing field ?
What will happen if boiler backfires?
I was absent for a 4 supply exams.. Will there any credit decrease for that exams in r16 regulation7
Define a uniformly distributed load.
we use parallel flow heat exchanger to coo oil of 1000 EP viscosity,oftenly tubes may damage during cleaning etc what is proper way to clean cooler? How impurities decreased or vanished during working or in less teme job performed?
What is the difference between an electric motor and an electric generator?
How do you reset the circuit breaker?
what precautions must be used when water washing a boiler?
If the black box flight recorder is never damaged during a plane crash, why not the whole airplane made out of that stuff?
My vendor filled liquid oxygen in our 11000 liter capacity tank. He filled from 1400 MMWC up to 3200 MMWC. I followed the provided conversion table and found that we had been supplied 1800 MMWC liquid which is going to yield 2815 cubic meter. On the other hand, the vendor claims that he supplied as follows:- 5236 cub mtr(3200 MMWC)-2124 cub mtr(1400MMWC) = 3112 cub mtr. I fear that he wants to charge 297 cubic meters extra. He claims that my method was wrong and his was right. He says that this disparity is because of the conical shape of the base of the flask. I will be thankful if somebody can explain me the truth.
What are the causes of turbine vibration
