Interested to Buy Any Domain ? << Click Here >> for more details...
HOW TO FIND OUT 1. LINE CURRENT, 2. PHASE CURRENT IN AN
ALTERNATOR / TRANSFORMER WHICH IS FEEDING A I)STAR LOAD ii)
DELTA LOAD, USING A CLAMP METER.
NORMALLY WHEN WE USE CLAMP METER IN A DG SET THEN WHAT DO
WE GET?? PHASE CURRENT OR LINE CURRENT.
- 13 Answers
- 36286 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / subrata sur
In clamp meter we get line current because phase current is
only inside the alternator.
Now for star load,
line current = phase current = clamp meter reading
and for delta load,
line current = clamp meter reading
phase current = clamp meter reading / 0.732
| Is This Answer Correct ? | 8 Yes | 4 No |
Post New Answer View All Answers
how to handle 2500 kva transformar
What is the general power consumption rating of CPU CRT type and Flat type, Monitor,Printer, projector, Scanner?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
Define active and passive network?
Formulae for calculating the transmission line losses for different voltage levels
How can we calculate cable size in Low voltage & high voltage
Explain what cmos is and its benefits?
How is magnetic leakage reduced?
what is the breaking capacity and making capacity of circuit breaker and how
Mention the methods for starting an induction motor?
where was current transformer protection units used and why??
On what cycle does thermal power plant operate?
WHY THE RATINGS OF THE TRANSFORMER IS 33KV WHY NOT OTHER???
Please provided formula for calculate the cable size from step up transformer to M.V panel, run overhead aluminum cables, total load is 5mega watt, total length 900 feet.
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
