Interested to Buy Any Domain ? << Click Here >> for more details...
hi friends i have some problem regarding technical round
ahr round plz tell me what should the right answer
technical questions
1 what is brouter
2 what is the menaing of 10 base2, 10 base 5 and 10baset
3 what is diffrence between bit rate and baud rate.
and this question was tooooooooooo much difficult to me
that
hr said to me that
rank me after the taking the all short of interview
- 5 Answers
- 6919 Views
- I also Faced
- E-Mail Answers
Answer Posted / jitendera sinha.it@gmil.com
hi i am jitendera sinha. and i am trying to give that answer
1 Brouter=bridge+router is called brouter.in another we can
say that the router which have both brifge nad router
property is called brouter.
2 10 base 2 is ethernet term trhat consern with datta
tratnsfer take place at speed of 10mbps/s having lenthg of
section 100 meter with two contiguish segment.
similary 10 base 5 is alswo a etehernet terme nad having
data transfer rate 10mbps havinf 5 continious segment
oflength 100 m
3 same as 1 and 2 but applyed for twisted cable
4 bit rate=numbaer of bit /sec is called bit rate
baud rate num
ber of bit/n
naswer of hr question-
if i will be there then i will say that sir as far my
consern u look very much anlaytical and methdical and pay a
silent view no ranking has be done
thanks
n=signal shift
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Define the igp (interior gateway protocol)?
Which way of communication bus topology use?
Name the command we give for see routing table?
Tell me which cable we connect in db-9?
Can you describe the Authentication Header (AH) Protocol?
What is the difference between static ip addressing and dynamic ip addressing?
Explain what is 5-4-3 rule?
When configuring a router utilizing both physical and logical interfaces, what factor must be considered in determining the OSPF router ID?
Explain the difference between static and dynamic routing?
Explain the difference between named and extended acl?
What does protocol mean?
What is topology in ccna?
What do we check while configuring the server?
Which multicast ip eigrp protocol use?
Why we used Virtual MAC in GLBP
