Interested to Buy Any Domain ? << Click Here >> for more details...
motor and transformer working with same principle so why
motor rotor was roted and transformer not roted
- 9 Answers
- 14006 Views
- ABB, Suzlon, I also Faced
- E-Mail Answers
Answer Posted / giridhar
in motors and in generators the winding is distributed
whwrer as in trf winding is concentrated.
| Is This Answer Correct ? | 13 Yes | 25 No |
Post New Answer View All Answers
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
which type of stability limit is higher,steady state or transient? why?
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
Who are the manufacturer for Nitrogen based Fire Protectio/explosion prevention for Oil Filled Transformers? India and international both?
WHAT IS THE PARTIAL DISCHARGE TEST?
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
why do we need to use 3c+3e cable, normally i select only 3c+e cable and i think it is enough. pls explain the usefull of 3e cable ( in this project the earthing system is well done)
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
What is meant by earthhing of a magnetic flow meter and when to use empty pipe detection?
what is the transformer turn ratio formula and give some examples?
a 100mva,400/200v transformer has leakage impdce of 10% draws a steady state line currentof---------------
i have done diploma and btech in EE and live in Chandigarh so kindly help me how can i make my competency certificate in my area.
I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
im working in one private compeny in gujarat. i was complet diploma electric in 2010 from gujarat technical board. now i want electric supervisor licence in gujarat but i dont't know when i apply? plz give me address of the licence dippartment office in gujarat. gandhinagar
