Interested to Buy Any Domain ? << Click Here >> for more details...
Can HT cable(11kv cable) be used for 415V, 700A requirement.
- 5 Answers
- 13559 Views
- I also Faced
- E-Mail Answers
Answer Posted / ashish baluni
Cable used for HT is designed for High Voltage and low
current carrying capacity. But for Low voltage rating
current requirment is very high which would cause Excess
heating in cable and will result in Puncturing of cable at
weak point.
For Ex- HT side Power=HT Vol* HT Current,if this cable
would be used for Low voltage then Power will be same. Thus
LT Power= HT Power
> 415*700 = 11000* I (Power factor is assumed to be unity)
> I= 26.5 Amp (For HT cable)
Thus,HT cable cant be used for Low voltage at High Current.
| Is This Answer Correct ? | 16 Yes | 1 No |
Post New Answer View All Answers
why we take movement of rotor always in counter-clockwise direction in 3-phase induction motors?
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
Why in ESP Positive earthed
condition Autotrip facia come on control panel of electrical transmission line?
I need the recommended size for a 3 phase transformer at 13.8 KV Primary and connected loads of 3000 kVA at 4200 volts and 2375 kVA @ 480 volts AC.
how do you choose the cable size as per amps rating & the voltage drop for the same.
which is better to use svc or synchronous condenser why ?
why ten delta testing is carried out on power transformer
What is UPS and How do you maintain the UPS Maintenance? Brief Description on UPS maintenance.
In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?
Draw the DOL starter and star delta starter drawing?
Why is tan-delta test and capacitor measurement done on alternator?
Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.
what is frequency response?
What is the difference between Delta & Wye windings?
