Answer Posted / arun singh

extraction is done basically for increasing the feedwater
temperature for proper deaeration which is acheived at 105C
and is further steam is extracted the work done for
generating power is reduced thus.thus more extractions are
restricted

How to find rating of Chiller a.c. plant i.e. how to calculate the a.c. load of an area, feeded by Chiller ?

4136

---

Dear Friends I want to previous 5-10 years technical and non tech. question paper of section engineer (mechanical)of RRB and also tell me how should I prepare for S.E. and which books will help me for technical,aptitude,resoning.plz send me at bkcs.bkcs@rediffmail.com

1858

---

differentiate between total moisture and inherent moisture of coal.

1046

---

why there was 17 stage of compressor in the most of the gas turbine . depending on what?

2051

---

I got i20 for university of bridgeport,university of new heaven and eastern michigan university.Please tell me visa success rate for these universities.And I want to go to Connecticut.At that place two universities are avaliable one is new heaven and the another one is bridgeport.Which is the best? Please give reply as early as possible.

2350

---

If the black box flight recorder is never damaged during a plane crash, why not the whole airplane made out of that stuff?

1239

---

What is the use of pneumatic system?

1110

---

What are the causes of low compression in the main engine?

1850

---

Why an increase in area is required to produce an increase of velocity in case of supersonic flow ?

1007

---

What is a liquid flooding in refrigeration system?

2280

---

why does polytropic efficiency of a compressor decrease with increasing flow rate ?

2533

---

sampile paper for dme in rrb exam

2889

---

What is the difference between tube and pipe?

1682

---

What are the causes if one cylinder in a diesel engine has a high temperature?

1988

---

What are the different types of gate valves?

1075

---