railway exam in asst loco pilot
old test paper
Answer Posted / brambhakant
yes
| Is This Answer Correct ? | 73 Yes | 14 No |
Post New Answer View All Answers
What is the reason behind current flow(20 A) in amain earth cable of an SMDB? Is cuurent flow(45A etc) through a neutral cable acceptable?
Is better to supply the voltage for static exciter from the auxiliary power source or from the SG terminals? And why?
How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
why three phase capacitor takes unbalanced current in capacitor bank?
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
How will polarity test of Dy5 Transformer ?
A motor running with lenze frequiency inverter stops if I REDUCE SPEED with 25% load.If I run it in High speed and medium speed running smoothly with full load.please help me to solve it.
Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?
Why is water motor not taking the pressure? what is the problem?
Define phase cross over?
why ten delta testing is carried out on power transformer
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
What is the power requirement of tamil nadu for one month?
What is difference is of VSD,VFD,VSDS, are they the same as the direct current to control dc using above mention
when ID fan will immediately stop through VFD what exactly cause and problem the ID fan