What does the "IPX maximum-paths 2" command accomplish?
A. It enables load sharing on 2 paths if the paths are equal
metric paths.
B. It sets up routing to go to network 2.
C. It is the default for Cisco IPX load sharing.
D. It enables load sharing on 2 paths if the paths are
unequal metric paths.
- 3 Answers
- 9824 Views
- I also Faced
- E-Mail Answers
Answer Posted / nishant
Limits the number of paths for load balancing to 2 (4 =
default, 6 = maximum).
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is segmentation and fragmentation?
Which type of transmission bus topology support?
How many reserve ports?
What command do we give if router IOS is stuck?
What is refresher?
What is the usage of service password encryption?
What is the draw back of eigrp protocol?
What is the ieee standard for wireless networking?
What are the ranges of private ips?
How do you depict an IP address?
Tell me which cable we connect in db-9?
2500 Value in which type of access list?
What we called 64 bit mac-address in ipv6?
Briefly explain the conversion steps in data encapsulation.
What is ospf? Describe it.
