Identify the command to configure the router for IGRP autonomous
system 100?
A.) Router(config)# router igrp 100
B.) Router> router igrp 100
C.) Router# router igrp 100
D.) Router(config)# router igrp
Answer Posted / haja bahurudeen m
Answer : A
Autonomous system configured in configure mode.
Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
After how long ospf exchange its topology table?
what is the difference between a ‘half-duplex’ and a ‘full-duplex’ system?
Which layer called error detection layer?
What is 10baset ethernet lans?
What is bia?
What is quality of ipv6?
What is the difference between an igp and an egp?
What are the different IPX access lists?
What are 10base2, 10base5 and 10baset ethernet lans?
What is the minimum and maximum request timer?
What is the difference between tracert and traceroute?
I simulate ten routers r1 to r10 straightly. I want I can ping from the loop of r1 to loop of r10, but I want I cant ping r1 and r10 from inside routers.?
What are the different types of password used in securing a cisco router?
Which ipsec rule is used for the olympia branch and what does it define? (Choose two)
Tell me how many hop counts are by default and how much you can increase in eigrp protocol?