Answer Posted / rajesh
Because of the Burden resistance of the Instruments/Load of
PLC are normally 250ohms
So Its Corresponding we will get 1 to 5V
| Is This Answer Correct ? | 6 Yes | 12 No |
Post New Answer View All Answers
What is the difference between working pressure and calibration pressure of a control valve
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
In Safe Guarding test what means by "Failed to Danger" ?
Explain an adaptive / self-tuning controller’s major draw card.
What is force balance principle? State some of its’ advantages.
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
how to calculate signal cable sizing? and multipair cable sizing??explain in brief?
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
Programmable Logic control.
what is orfics working in main steam line. is it increase pressure, velocity of steam flow and dicrease steam flow rate. or any other
how to calculate control valve bonnet size?? or how to select its material?
what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?
why we use cascade control and feed foreword control in 3 element control of boiler drum ?what is feed forward and cascade control system ?
How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?
what is cems analyzer explain with principle and drawing ?
