What is the diffrence between four strock and two strock ic
engine
- 14 Answers
- 24533 Views
- Alkem Labs, Mechanical, I also Faced
- E-Mail Answers
Answer Posted / abhishek kapuria
For 4 stroke :
a. Valves are used.
b. Heavy flywheel is used.
c. Thermal efficiency is high
d. For two revolution of crankshaft one power
stroke is produced.
For 2 stroke :
a. Ports are used.
b. Lighter flywheel used.
c. Thermal efficiency is low in comparison to $ stroke
d. For one revolution of crank shaft one power stroke is
produced
| Is This Answer Correct ? | 20 Yes | 1 No |
Post New Answer View All Answers
Sir, In the current session I am attending the Junior Engineer Exam in Grade II for Mechanical Engineering. If it possible. Please sent the Past Exams Question on my mail. It is so useful use to me.
How much stack emmission through your chimney and what is the state govt norms ?
Sir, I'm P.Ravi Kumar want to previous mechanical Question Papers for rrb exam
Dear sir-I WANT LAST FIVE YEARS RRB-CHENNAI QUESTION&ANSWER PAPER IN J.ENGG(GRADE:II)-MECHANICAL ENGINEER
present salary with all benefits (ctc) please give breakup it possible ?
Hello sir, I am Rajaram. I have finished DME (Diploma in Mechanical Engineering). I would like to attend BHEL supervisor examination. So i want which type of questions can i prepare. & give previous supervisor examinations questions. Reply my mail (rajaramsptc@gmail.com)
Given a cutaway isometric view of the steam turbine.
RRB exam qustions.
i need iocl model aptitude question papers soon as possible .so pls 4wd it to m id akakil1820022gmail.com
i am preparing for motor vehicle assistant inespector please send me old questions papers.
How to convert GSS duct volume in KG for all guages
i have want jindalsteel tecnical wrritten test paper.
Study the attached ACS 790 AHU and boiler GUI and refer to the video on the software usage, catalog and the step by step document (page 9) to perform the following task: List in a table form the controllers and all their connected I/O for the boiler and the AHU.
What will be expected the cut-off of J.E Mechanical exam of RRB on 19/12/2010 ?
i have completed b.tech from mechanical engg so plz send me some question paper for entrance exam
