Interested to Buy Any Domain ? << Click Here >> for more details...
My requirement is 1VA,50/5A Current Transformer for
Metering .If I select 15VA , 50/5A CT.Is there any
possibility of Technical Problem ?
- 6 Answers
- 9015 Views
- I also Faced
- E-Mail Answers
Answer Posted / c r venkatesh
Absolutely no problem.you can always use higher burden CT'
without any problem
| Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
Difference between HRG and NGR. Are they both the same thing
What is the accepted limit to increase the choosen transformer capacity over the load and why ?
what is the minimum winding resistance of 30hp compressor, to run or to switch on
what is the formula of starting current of 3phase and 1 phase motor???
how does a submersible pump work..?
what is the ckt diagram of a tubelight and is it the simplest ckt of electrical engineering and also the component?
draw vector diagram and +ve,zero sequence diagram of symmetrical three phase fault.
Y phase plates are used in transmission line??? what is there need???
What is the comparison between 30mA DP RCCB and 100mA DP RCCB and can replace it against 63A MCB
Circuit diagram of tube light without starter using electrical choke
what is kondo syatem in eletrical traction
what is apparent poewr, reactive power, & active power?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
What are the advantages of hydropower?
