Interested to Buy Any Domain ? << Click Here >> for more details...
I have 1010 KVA Generator when i run the DG set for 5 to 6
hours the couplling (couplling joint in between engine &
alternator) bolts are getting loose what is the reason &
what is the remedy over this??????????
- 7 Answers
- 9565 Views
- I also Faced
- E-Mail Answers
Answer Posted / nagarajan
I Think u can make use of pins in the nuts at specified
tight point of bolt.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
How is natural gas better than lpg?
What are killed steels and what for these are used ?
how to select a pump (in hp) for lifting water from a Borewell upto a height of 320feet? Is there any thumb rule?
Give five differences between suction and discharge pipes?
Is it a good sign when thick smoke comes out of a Oil vapor extraction fan of a steam turbine oil sump? What does it indicates?
Draw a crankshaft and show the parts?
how many filters at durty side in air intake system in siemens v 94.3a
The efficiency of a pin fin with insulated tip is
How can i Check at site this material is Powder coated CRCA ?
How is a submarine able to submerge and surface?
can any one pls refer me any sites which have notes regarding Body-in-white(welding fixtures)...pls
What is brain of the computer?
What happen when too much cylinder oil is injected in the working cylinder?
about basic questions ofpiping engg
Explain how to clean LO
