Answer Posted / anilram
for perfect earting it should be zero ohms. for pratically
at site it 1-5 ohms . in large substations the should be
below one ohm
Is This Answer Correct ? | 22 Yes | 3 No |
Post New Answer View All Answers
how wecalculate breaking capcity of acb mcb mccb .explain with example
I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME
we have amp, voltage, kw, length detail then how to calculte copper & alluminium size of conductor of 3-phase induction motor
I want to put this query to SENIOR & EXPERIENCED ELECTRICAL ENGINEERS. 1)I want to know about the control circuit diagrams for control panels. I found it difficult to understand. Is there ant booklet through which we can learn the circuit diagrams? 2)I want to learn about conduiting, laying cables, preparing cable schedules and various techniques which is the part of building infrastucture(construction field). I don't have any experience in this area. I have experience in control panels only. that's why i am not getting any opening in building infrastucture (construction field).Can I get the job in this field as Trainee Engineer? How to enter this field? I need job in PUNE
How to calculate the current of Highpressure Mercury Vapour Lamp?what is the basis?whether we have to consider power factor or not?
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
What is a commutator?
What is meant by reset level of the relay?
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.
how braking & making capacity of circuit breaker are calculated?
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
What is the relation between frequency and motor rpm?
I am apply the AAI. So i want electrical sample question paper in technical with answer my id is vijayjobsmart@gmail.com
WHY BREAKER ARE USED IN SUBSTATIONS?
what is the formula of starting current of 3phase and 1 phase motor???