1.Can anybody explain Why starters are not used for motor
starting in industries?
2.
- 7 Answers
- 6623 Views
- I also Faced
- E-Mail Answers
Answer Posted / sennapparajan
oh/...well frnd...u must have seen at any small industries.
they must have used be cos of cost.U can never find in any
standard company.it may happen if its very low rating motor
like up to 0.33kw.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
can any one suggest paper presentation topies for electrical engg?
how ceiling fan worked?
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
how to calculate slip ring induction motor stator and rotor currents??
hi all i like to know vat is power plot in control systems also i want to know abt latest trends in electrical & electronics
How does "OUT OF STEP" relay ,for Synchronous motor protection, work?
induction 3 phase motor terminal connection
Define resonant frequency?
how to build a network which step down 415v to 1v rms
How to design the NGR Resistance
What is vaccum currcuit breaker.define with cause and where be use it device?
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
How to convert a two phase power into a three phase power in induction machine?
WHAT WOULD BE THE FORMULA OF WIRE GAUGE FOR A FULL LOAD CURRENT
How to assume answer to electrical questions
