Interested to Buy Any Domain ? << Click Here >> for more details...
how many earthing should need for UPS, where its connected
- 7 Answers
- 12834 Views
- HCL, I also Faced
- E-Mail Answers
Answer Posted / vasu
2NO'S of earthing one of the body earth and another one of
equipment earth.
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
Has someone here done a sizing for a generator (3 phase), its for a pumping station. If you have an example for standby/duty and both running (I) star delta (ii) Soft Starter.
Can I use distributon class/transmission class Lightning arresots for protecting the building? If not why please explain?
What is meant by cold loop test in instrument
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
if voltage bt phase & nutral is 38v in a panel board . whats the root cause.
can we install HT panel & LT panel side by side or how much clearance is required ?
i have install 750 kva distribution transformer at my site and want to do neutral earthing. what calculations should i follow to determine earthing conductor material and size?
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
what are the difference between PLC and embedded
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
why the NGR (neutral grounding resistor) always OFF during DG off?
Difference between ac parallel circuit and ac series circuit?
How do we calculate over and under frequency tolerance from generator data?
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
