what is the difference between upper impedance and lower
impedance distance relay?
Answer Posted / bl meena
upper-above which not operate
lower-below which operate
Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
I need the list of Universities who have summer intake for BS degree in Electrical Engineering.?
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
How to calculate the Harmonics losses in terms of cost/unit.
What is milivolt dop test in Busducts? What is its significance & procedure to do the test?
how to calulate short circuit current for the following: 1.cable connecting 11KV of 22KV/11KV transformer to 11Kv of 11KV/415V transformer 2.what cable size should i use.
Why Utility Distribution System in India is mainly at 11 kV? Why not Utility go for 33 kV?
What are differences between Voltage, EMF & Potential difference ?
How to select a cable size for particular load?
I have 4 DG set with 1500KVA rating. system breakers are 11KV & alternator are 415 Volts. Between alternator & breaker one stepup transformer used. i want to Know what is max. resistance for body earthing & 415 & 11KV V Neuteal earthing. my fault current is 14 times for 2 sec.
why magnet has north and south poles only why not east and west and why we are considering as north and south poles? why cant we consider as east and west?
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
HOW TO CALCULATE THE REGULATION OF 100 AND 25 KVA TRANSFORMER
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
1. What is maximum permissible distance between smoke detectors ? 2. How do we decide number of smoke detectors required in a large office, warehouse, hall etc ? 3. What should be maximum height of smoke detectors ? 4. Where do we use heat detector, optical smoke detector, temperature sensitive detector ?