Interested to Buy Any Domain ? << Click Here >> for more details...
According to general circuit diagram of 1-Phase t/f , why
the primary is not get short circuited ,even though the
supply terminals both are directly connected through
primary winding?
- 4 Answers
- 5659 Views
- I also Faced
- E-Mail Answers
Answer Posted / pratheesh
How it will get shortcircuited. The primary winding has
impedence(Resistance+inductance).
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
Why air circuit breaker off due to power failure?
How to measure the earth resistance value in a concrete pavement(flood light area)?
physical identification of HT & LT panel
I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.
why does rotor rotets?
In both 600/1000 V cable and 450/750 V cable, we can supply 415 V. However for distribution, all utilities are using only 600/100 V instead of 450/750 V. What is the reason?
What are your future plans for the company if permanently employed?
how to deside the capacity of chock for drive?
State the formula for overall efficiency of thermal power station
what is the main difference between power devices and signal devices
How does an oscillator differ from an amplifier?
What is the Surge suppresor? Why using in a UDB's and How it works?
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
What is the loss of power of transformer 220kv/33kv,63/80mva of % imp12.05 at 80%load
difference between power surge and switching transient
