Answer Posted / s.senthilkumar
init 0 -ok prompt(open boot prompt)
init 1- single user with system administrator mode.
init 2 -multi-user mode.
init 3 - Extend multi-user mode
init 4 -Is available to be defined as an alternative
multi user environment configuration. It is not necessary
for system operation and is usually not used.
init 5 - Shut the machine down so that it is safe to remove
the power.Have the machine remove power, if possible.
init 6 - Stop the operating system and reboot to the
state defined by the initdefault entry in /etc/inittab.
| Is This Answer Correct ? | 3 Yes | 6 No |
Post New Answer View All Answers
what are the alarms in solaris?
what is the difference between solaris8 and solaris9 and solaris10
How to create core dump and crash dump #coreadm .
How can u find a file which is logged in last week?
Hi We have upgraded our sun machine from solaris 9 to solaris 10. Before upgradation the date command output(Solaris 9) Wed Oct 13 09:45:21 IST 2010 But after upgradation the output for date is as below(solaris 10). Wednesday, October 13, 2010 9:46:14 AM IST Looks like I need to change LC_TIME=C. can you please help me how to change it for permanently
There are two nic cards on a sun server. I need to connect one nic to pupic ip and another nic to DMZ. Could you tell me how to configure step by step?
How to make SUN server as router in subnetwork?
After first installation of Solaris 10, what and all the Securities We need to set and how ?
How to add a new LUN in exit disksets (metasets) in solaris please answer me step by step procedure?
please post step by step installation of packages from the EIS cd..
Where do you get Alarm prompt?
If the root disk is failed how can change it?
What are the differences between the command line and graphical user interface?
How to configure email notification in solaris 8? We are using netbackup 5
What does pkgadd command do?
