Interested to Buy Any Domain ? << Click Here >> for more details...
what happenes if two voltage source connected in parallel
will be connected to load.
- 3 Answers
- 17303 Views
- Efftronics Systems, I also Faced
- E-Mail Answers
Answer Posted / z_hosen
Good question..
If u want to connect two voltage sources at first u have to
follow some rules like
1. Phase sequence should be same
2. Frequency should be same and
3. Voltage should be same
if any two or more voltage sources which don't follow the
above conditions then current will be Inter circulated
between sources and if the voltage range is more then the
system will be damaged..
thanking u..
z_hosen@yahoo.com
| Is This Answer Correct ? | 54 Yes | 4 No |
Post New Answer View All Answers
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
how can decide the current rating of oltc
my bachelors was done with EEE now i got admit in NU with CS as course. how to answer this qns 1) why u choose cs? 2) why u changed from eee to cs
How does a battary stores charge in it? please explain in simple manner and in detail.thanks
Dear sirs, pls check this 4-20ma to RS485 module datasheet,pls guve me some suggestions. http://www.szsunyuan.com/sy/pro_more.asp?Productid=539 Thanks. E-mail:yunianjiang99@gmail.com
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
magnetizer priciple
What is K-rated transformer? What is the use of it? What can be the size(pls provide calculation if possible) of K- factor transformer for 550kW,690V motor operating with drive (VFD)?
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
generally in LT and MV motors we are using 3.5Coresx16,25,35,50 etc cable for supply.although motors is earthed at two point and having all protection.then why we are using that 1/2 core for earthing the motors.while in HT cable we are using only 3core cable for motor supply.generally lt and mv motors are delta connected and ht motors having star connection.whethere it is having any relation with winding connection( star or delta).all motors i am talking about are dol only.can anybody solve my confusion.thanks...
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
What the formula for calculating no.of earthings & size of earth strip for 100mX90m shop.
What is evaporator & condencer & compressor
How much voltage we need to apply in 33kv cable during hipot test of cable
