Answer Posted / ayad basha

The general thump rule is one square inch copper conductor
will carry 1000 Amps and that of for aluminium conductor is
600 Amps. So, for Cu, 1sqmm = 1.6 Amps appx. and for Al 1
sqmm = 0.9 Amps.

but this will not fit for the increasing cable sizez.

for example for 400Sqmm cable, it will not carry 400 x 1.6=
640 Amps. That is the effective current density of the
conductor decreases as the conductor size increase.

Also depth of cable laying, ambient temperature and cable
grouping also should be considered.

if we give 60 hz single phase supply to the transformer used in europe , than what will happen

1931

---

why transmission is only 3 phase and not 2 or 4 or poly phases

2118

---

what is the minimum voltage require to injure our body?

6896

---

what is the chiller and working principal

2326

---

what is ramping rate of generator

2051

---

how to revers the direction of single phase motor

956

---

Either the Armoured Earthing strip of HT 3 core cable have to pass through CB CT or not , why ???

2078

---

What is dynamo?How it works and what is the function of dynamo in a DG.

2158

---

How to check 11000/1.732 to 110/1.732 Potentila transformer (PT)?

2197

---

is it possible to test of bus bar in high rise building without completed full floor ?

1680

---

Is there any reason that we get shock on touching phase wire because the earth is at neutral potential? Is there any reason that the earth is at neutral potential because the neutral is earthed in apower station

2006

---

What is the ratio of true power to apparent power in an ac circuit?

1136

---

why to use freewheeling diode ( diode in revers bias mode) across dc coil

5004

---

what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY

2196

---

Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?

1867

---