Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / santosh
pile foundation is the type of deep foundation where the
load transfered below the deep soil strata.load transfering
can be done following two way
1 end bearing of piles
2 skin friction
3 composit method
| Is This Answer Correct ? | 23 Yes | 20 No |
Post New Answer View All Answers
i have to give lap joint fo 1Mtr steel of dia12mm,whenever i did mistake i cut less 5cm plz tell me how much i will give lap joint so that length comes 1Mtr
Doul Bar reinforcement and details of drawing.
How to do rate analysis for concrete work including shuttering work?
What year was the keystone power plant in Indiana County constructed?
What is an ice dam sock?
Analyze the rate for 1st class brick work in superstructure with 1:6 cement sand mortar. Consider 1000 cu.ft quantity and work out the rate per cu.ft
what is meant by shear center?????
What is the basic difference between OPC
Can we use concrete of slump cone in cube casting in which we have already measured slump?
how to decide the mortar ratio 1:4,1:6 in masonry? same in plaster 1:3 and 1:4? which code or any document reference taken to define proportion?
Explain soil analysis?
What are the advantages and disadvantages of using plastic and timber fenders?
Is it necessary to apply tack coat over the primecoat. IF not what happens.answers other than 1.to superimpose the next layer(2) to adhere the layers so as to form homogenity.
How do we calculate absolute pressure?
what should be RCC material i.e iron rod(mm)x cement x stone x sand for laying of slab L 42'x B 22'x tk 0.375ft = 1nos & column of H 17'x15"x8" 2nos.
