Interested to Buy Any Domain ? << Click Here >> for more details...
why we used to transmitt the power at higher voltage why
not at lower voltage
- 8 Answers
- 9730 Views
- I also Faced
- E-Mail Answers
Answer Posted / prashant
This is directly related to ohms law V=IR. now from this
its quite evident that V and I are inversely related to
each other. So if V is higher then consequently the I will
be lower and hence the size of the conductor neede to
transmit the power will be small.Considerable cost saving
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
What are the advantages of skewing of cage rotor conductors?
what will be project cost for 100 kv transformer connection under oyt scheme.
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
I am a electrical engg. diploma holder,applied for junior engineer (electrical),Kolkata RRB. Have I to attend all electrical,mechanical&civil portion in written exam.???
diff b/w elcb and rccb
why we are using earth pit in sub stations.?
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
is there any role of power factor with frequency variation? and how we can manage the frequency variation?
What is the accepted limit to increase the choosen transformer capacity over the load and why ?
how to select the double earth conductor if 21A full load?
1.how many earth pits are required for 1000 k.w plant include substion , transformer ? 2. how many earth pits are required for 500kva generator.what is formula to calcute?
What is power distribution criteria for converting single phase unbalanced residential load to 3 phase star connected balance system. Does total KW converted to 3 Phase. Means Divided by root 3.
What is miller crystal oscillator? Explain its operation?
What is a dominant pole?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
