In winter we seem lightly an electric shock when we touch
to doors(sometime)
Answer Posted / ravi juniper
when fuse carry neutral, possible to shock in taps kitchen
equipments etc. solution is fuse should carry phase only.
| Is This Answer Correct ? | 1 Yes | 6 No |
Post New Answer View All Answers
How to decide and select the different earthing wire size for the different types of earthing
we have 2.2kw,Y,3000rpm motor but 6leads found in TB what happen if we connect in delta?
if i get a drop in my 1st year and the i clear my 2nd year and 3rd year all clear and i dont have any back logs so can i be able to sit in campus selection??
What does the term “voltage regulation” means?
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
According to conduit size which size wiring & how many wires can we provide wires in conduit & how can we select conduit size accordingly?
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?
What is slope...? Explain slope 1 and slope 2...?
what is metering cum synchronizing panel and how it is used?
What is the maximum percentage voltage drop (vd%)for a motor control center
How can we increase fuel-power ratio of any DG set?
can any one suggest paper presentation topies for electrical engg?
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?