Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / loki
E=4.44*A*B*N*f
where A=area of cross section of core
B=fux density
N=no.of turns
f=operating frequency
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
why the NGR (neutral grounding resistor) always OFF during DG off?
why starting current is high and resistance is almost 0 during the starting of motor dc motor...?
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
why ups rating in kva? and why ups are in parellel?.why isolation transformer is used in ups?
What is Surge Capacitor? Why it is use in Generator Circuit Breaker?
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
describe the phenomena of vacuum interruption in C.B
State the other types of Air Conditioners?
in india per day how much power is generated including all power station
what is tri state logic gate
how calculated Transformer losses.
66kv under ground cable how to layaing in ground any special case two ckt r runing
