If the supply voltage is same (say 440V) whether a system
designed for 60 Hz frequency will work with 50 Hz frequency
or not , if so pl. give clarification.
- 11 Answers
- 13160 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / joysbag@gmail.com
E=4.44(freq.)x(fluux density).
if E is constant - freq is inversly proportional to Flus
density.
Hence with 10% decrease in freq the flux density will
increase by 10% which may bring the transformer at
saturation. Hence it may work but not advisable.
| Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
How do I calculate/select Droop CT ratio for various capacity of generators?
ELECTRICAL DRIVES: can a motor load system with passive load torque can have equilibrium speed in second quadrant
wat system call?
I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL. 1-IS BETTER WE USE CABLE? 2-IS BETTER WE USE BUS DUCT? my transformer rate power is 2500KVA
what is kondo syatem in eletrical traction
how r charge carriers produced
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
Write the force balance equation of ideal dashpot element.
what is the difference between linear choke and suction choke?
in single phase converter, the no.of scr's conducting during overlap a)1 b)2 c)3 d)4
What is online and offline ups? how does it works?
How much load can take a 16 mm aluminum cable 3 phase
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
Control wiring of a dol starter for forward and backward
