Answer Posted / kumar.m
I a capacitor bank Step by step put in load & check each
phase amps (current) by using clamp meter,compare all phase
& observe some amps difference.
Is This Answer Correct ? | 14 Yes | 12 No |
Post New Answer View All Answers
What is nichols chart?
what is the control circuit for operating the clean room air shower
ELECTRICAL ENGINEER TEST IN FEWA ANY ONE HAVE KNOWLEDGE ABOUT THIS?????????
how can maintain the power factor and why and this is how do work tell us
11000volt DG set carnt kaise banvay
what is the electrical?
what is Fault level? why it is calculated? how will u decide same for our plant?
why 3 phase is converted into 2 phase using electronics circuit why not 2 phases are diresctly putted from the 3 phase transformer??
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
how to extend relay operating timing in 24V dc relay card (without using Timer )
State the frequency for rc phase shift oscillator?
what is doubling factor in making current of a breaker?
please send me RRB electrical engineer previous year questions for Sr. Section Engineer
What is the reason that the humming sound is coming from the induction furnace panel?
Where burned of electricity,when,who, & why.