Interested to Buy Any Domain ? << Click Here >> for more details...
8. When is Frame Tagging used?
A. When you install repeaters in your network
B. When you install bridges in your network
C. When you install routers in your network
D. When you use Switches configured with multiple VLANS
- 5 Answers
- 12957 Views
- I also Faced
- E-Mail Answers
Answer Posted / jitendera kuamr sinha
ans d
ram has write the wright answer but explanation is
wrong.frmae taging is not used for communication b/w
vlan.if frame tagging is used for intervaltion comunication
then what the need of router thats called intervlan
communications
ok
the wright expalnation is that when we trunk the two or
more then two switch then the comunication bewwwen same
vlan which are plased at diffrent vlan frme taging is used
this is the wright explanation of franetaging.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
in stead of 0.0.0.0 wild card mask what u can write after ip?
After how long keep alive messages exchange in eigrp?
Explain the types of nat?
Why we use debug command?
Can you explain static and dynamic tunnels?
What is default size of hello packets in ospf?
Explain how many maximum paths you can give on latest ios in rip?
Which peer authentication method and which ipsec mode is used to connect to the branch locations?
Explain the term 'multicast'.
What is difference between baseband and broadband transmission in ccna?
Tell me how many fillers we can put in one ip of ipv6?
Given the configuration example: interface ethernet0 ipx network 4a ipx access-group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network tc access-list 800 permit 3d 4a Which action result from implementing this configuration? a-Traffic from network 3d for network 4a will be forwarded out e0 b-IPX network 5c will not receive any traffic c-Traffic from network 3d, destined for network 4a, will be forwarded out e2 d-Traffic from network 3d for network 3d will be forwarded out e0
What are the ranges of private ips?
What does the meaning of interface 0/0?
What is topology in ccna?
