Interested to Buy Any Domain ? << Click Here >> for more details...
1.generator rated as 1000 mva,11kv .8 pf what will 0.8 pf
will indicate?
1.max pf it can supply 2.min pf it can supply
like this 4 options there what is answer.explain
- 5 Answers
- 14165 Views
- Power Grid, I also Faced
- E-Mail Answers
Answer Posted / sukhvinder
the above mentioned genrator Ans is 1.
it can supply max. load i.e 0.8 pf means 80 percent of rated
1000*0.8=8MW.
| Is This Answer Correct ? | 11 Yes | 2 No |
Post New Answer View All Answers
Define ohm’s law for a.c (alternating current)?
ITI r/tv trade APPLY (J.T.O VACANCEY) ALSO INCLUD AITT ELECTRONIC,WRITEEN XAM DONE 23.03.10 BUT NO RESPONCE WHY ANATHER ID gopal_gh007@rediffmail.com
why the name trunking bus PT
How we can recongnise the phase displacement of transformer connection between primary & scondary...plzzz explain it with example.........
If i have two 3000 kW motors and the whole facility requires a 10 MVA transformer. What would be better installing two 5 MVA transformers(one for 1 motor ) or just a single 10 MVA transformer for both of them. Give reasons for your answer.
The specific heats of the gas at constant pressure and constant volume are respectively 1.0 kJ/kg K and 0.72 kJ/kg K; the value of R for the gas is
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?
WHICH SIZE A.B.CABLE IS USED FOR 11KV.
Explain the operation of variable frequency transformer?
How to select the gauge of wire for winding of motors? How to select number of turns for winding of three phase induction motor?
what is meant by motor startup supervision & motor load jam protection ?
advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
how to select proper cable for ct wiring so that drop within the limit.
