Answer Posted / rk
ELR or commonly known to be EL CB . all 3phsaes and netral
of the incommin supply passs throuh oone ring type ct so
that there will be no current in CT secondary if there is
healthy system but in case there is a ground fault at load
end the cT will record the unbalance current and the relay
will sence the fault.beacuse durring ground fault the fault
curent will pas througth ground to the sourcr insted of
throug the neural inside the ring CT.
Is This Answer Correct ? | 40 Yes | 3 No |
Post New Answer View All Answers
Load break swicth maintenance procedure.
What is the polarization index value ? (Pi value)and simple definition of polarization index ?
What is ramp signal?
how ups works ? various parts of ups and working principle
explain the mode of metal iranafer in Co,welding
Where voltage are high and current to be interrupted is low the breaker preferred is:
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
in 132kv substation CRT means
what is the differance between HT motors And LT MOTORS.
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
Which type of questions well asked. ?
full form of flry b
what is smartµ grid technology?under coal gassification?
Can any body tell me about INNER SHUNT COMPOUND MOTOR diagram?
what is the use of piston rings in the engine used for a generator...........