Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mayur patel ahemdabad essar st
its any kind of study of electrons.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What do you mean by phasors?
A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.
What is meant by coupling capacitor?
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
How to design harmonic filter at the project stage without nowing the harmonics levels
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Q) Write VBscript code along with QTPscript code in QTP tool for below scenario 1. Launch yahoo site(i know) 2. Do loogin(i know) 3.Click inbox link(i know) 4.Go to every page of mail box and count no.of read mails and no.of unread mails(i know) 5.Store page numbers, read mail count and unread mail count in a new excel file sheet 6.Create 10 types of graphs on that data 7.Do logout and close site(i know) 8.Save new excel files with graph
Wind mill
Where should the lighting arrestor be placed in distribution lines?
What is the RMS and DFT principle of analogue maesurments. Which way they are advangages. where which princples give optimum results.
Explain about 3 phase motor fault current calculation with examples?
list the type of vfd? wich is sutable for heating kiln?
What are the applications of the electric motors?
what is the meaning of 0.5ohm Resistance
Which do you think is the most significant cause of energy loss in a factory?
