Interested to Buy Any Domain ? << Click Here >> for more details...
I WANT TO KNOW LONGFORM OF CT/PT USEDIN POWER PROJECTS OR
HT SWITCH YARD.
- 7 Answers
- 15264 Views
- I also Faced
- E-Mail Answers
Answer Posted / binod
CT is called as current transformer and is used for
measuring current.it is always used in series.normally it's
secondary is rated 1A or 5A.
PT is called as potential tansformer and used for measuring
voltage.it is always used in parallel.normally it's
secondary is rated 110v.
| Is This Answer Correct ? | 17 Yes | 1 No |
Post New Answer View All Answers
difference between a diode and thyristor?
draw the restricted earth fault protection circuit install on power transformer and identify its parameters and draw C/C curve of it
WRITEDOWN FEW RELY CODES
what are safety measures in /control in diesal engine/ explain them?
what is the acceptable limit value for Desolve Gas Analysis/
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
what is the effect of earth on capacitance in 3-phase and 1- phase transmission line?
What is a feedback in control system?
how to measure the current by compact digital equipment with dislay which fit inside any equipment
Show the schematic arrangement of diesel power station layout and give its principle of operation.
how to select electronic timer(Star-Delta) setting for diff. rating motors
how to design step down 12 V, 1mA small transformer from 220 V AC? Because according to VI relation and power transfer it results bulky...
1sq mm dc powr cable can carry how much dc currnt
is it possible to say motor horsepower number without seeing name plate(when name plate damaged)
why the rotor current becomes in steady state during high slip region? please verify with equations.
