Interested to Buy Any Domain ? << Click Here >> for more details...
how micro-processor and micro controller different from
architecture
- 3 Answers
- 8532 Views
- Bhushan Power Steel, I also Faced
- E-Mail Answers
Answer Posted / abdus sattar mollah
Microprocessor's have Von Nueman architecture i.e an
computer architecture where the program memory and data
memory are in the same memory hardware chip.So,both source
code(instructions) and the data are transmitted using same
bus.Also,in microprocessor the main CPU unit is in the
microprocessor chip ,other accesories chip required are
interfaced with the microprocessor chip ,externally.
Microcontroller's have Harvard architecture i.e both
program memory and data memory are in separate dedicated
mem0ry chip .Thus,different distinct buses transmitts
program codes and data.This result in increased speed but
also increased complexity in hardware.Also,all other
accesories chip like memory chip,I/o chip,Serial transfer
chip(USART) are within the microcontroller single chip.
This is the basic difference in architecture, due to which
several other diffrenece like access,working varies.
| Is This Answer Correct ? | 17 Yes | 2 No |
Post New Answer View All Answers
How to check vortex flow meter is in good condition while we do not having calibration setup?
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
what is the input of digital counter during the the calibration time?
Explain the difference between mmwc and mmwg?
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
how can use ram
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
what is the process to make control schematic ?
how many type conductivity sensor ?
What are different types of orifice plates?
Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
applications of plc in printing and packaging?
