How to select the Cable size for 550 Amps Load without
seeing the cable Catalogue?
Answer Posted / dilip singh
Normally if you go with the size of cable in catalogue, you
will observe the if cable is of 400sqmm thenit carries
about 300A current and similarly for other ratings so you
can guess by size of cable selected. but it will not be
correct all the time. may it will vary by some value.
Is This Answer Correct ? | 13 Yes | 5 No |
Post New Answer View All Answers
what is the function and use of cable differential protection relay?
Is phenomenon of resonance is harmfull fr the machine? if not or if yes please explain it?
What are the material used for resistor?
what is the common earth
can anyone provide me a amf panel control wiring using ec-2 relay?
HOW WE CALCULATE CURRENT IF THERE ARE NOT PRESENT ANY AMMETER OR MULTIMMETER??????
what does vector group Dyn11 tell us? also tell me how will u differentiate between phase lead and phase lag thru this vector group
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
what maximum range of star & delta in hp or kw ?
What kind of preventive maintenance are there for transformer?
what is meant by residual over voltage & residual earth fault ?
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
What kind of Neutral CT can be placed in 11/0.433KV transformer to be used and what are its specification?
Can anybody please refer the best and simple book for about Protection relays and in detail of all its protection ?