Interested to Buy Any Domain ? << Click Here >> for more details...
What does the 'S' mean when looking at the routing table?
A.) Statically connected
B.) Directly connected
C.) Dynamically attached
D.) Shutdown route
- 2 Answers
- 17073 Views
- I also Faced
- E-Mail Answers
Answer Posted / haja bahurudeen m
Ans : A
S - statically connected
R - RIP
I - IGRP
O - OSPF
E - EIGRP
| Is This Answer Correct ? | 14 Yes | 0 No |
Post New Answer View All Answers
What does synchronization mean?
What is the difference between bus topology and hub?
How do you configure a cisco router for routing ipx?
What is name of ospf algo?
Explain the difference between routable and non- routable protocols?
What are the different types of cables that are used in routing?
Explain on which interface we always apply access-list?
Explain the types of ospf configuration?
Briefly explain the conversion steps in data encapsulation.
When we use interface mode?
Explain why UDP is lease favored when compared to TCP?
Which peer authentication method and which ipsec mode is used to connect to the branch locations?
Which type for communication switch do?
Which protocol works only on cisco routers?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
