Why a starter is used for a motor?
Answer Posted / raviteja
THE RESISTANCE OF THE ARMATURE OF THE MOTOR IS MADE VERY
LOW IN GENERAL TO REDUCE THE LOSSES==>>IMPLIES THAT AS THE
RESISTANCE OF THE MOTOR IS VERY LOW,,IT IS ABLE TO GRASP
THE HEAVY CURRENTS FROM THE SUPPLY NEARLY 4-5 TIMES THE
RATED CURRENT OF THE MOTOR,,SO THERE IS A CHANCE OF DAMAGE
TO ARMATURE WINDING BCOZ OF THESE HEAVY CURRENTS,,SO,TO
OVERCOME THESE PROBLEMS,,A STARTER IS USED FOR THE SMOOTH
OPERATION OF A MOTOR WITH OUT GETTING ANY DAMAGE
Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What will be electrical cost per sqft for IT building (basebuild and fitout)and for residential township?
what is the minimum winding resistance of 30hp compressor, to run or to switch on
What is difference between unity power factor wattmeter and upper power factor wattmeter? In short circuit test of transformer the wattmeter used is unity power factor type or upper power factor type wattmeter?
Transmission voltage is kept 11KV,33KV,66KV,132KV,220KV due to form factor. What happen to 400KV and 765KV transmission voltage?
How calculated single phase induction motor req. Capacitor?
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
if a.c supply is given to the motor,, what happen?
What is dynamo?How it works and what is the function of dynamo in a DG.
What's the difference between non break power supply and non break non short break power supply
Where is the best place to mount distribution panel in a house.
what are the possible reaons & remedies if resistance of NGR getting heat up
Advantages/Disadvantages of earthing of neutral bus on MSB instead of separate neutral earthing for transformer/DG sets feeding to MSB
List the advantages of star-delta starter with induction motor?
What is meant by sag?