Interested to Buy Any Domain ? << Click Here >> for more details...
howmuch current can carry the 2.5Sqmm copper cable?
- 42 Answers
- 106050 Views
- I also Faced
- E-Mail Answers
Answer Posted / jokemaster
its the cable to carry the current and not the current to
carry the cable.:-)
| Is This Answer Correct ? | 38 Yes | 16 No |
Post New Answer View All Answers
ratings of lightning arrester
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
75 kw motor take 45 amp in no load delta in star 10 amp but in load it will take 160 amp but IR velue of winding above 500 at 1kw ph to earth and ph to ph. what problem it should be?
how to make an earthing certificate
Is potential difference materials property ..? if yes tnen how.. explain brifly.
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what is ps impedance test
Define piezo-electric effect?
at work i have a genertor/alternater what is the easyest way to work out if it is dc or ac?
why we use copper earthing for neutral while for body GI.
What is the differance between 2 dc motors of armature voltage 660 v and 440 v?
can u give me a brief idea about power line carrier communication ??
How to select a transformer group to connect a 0,433 KV generation with 33 KV grid in bi directional flow of current
how choose conductor&depending upon load
