Interested to Buy Any Domain ? << Click Here >> for more details...
How we find the size of cable if we know the current
- 2 Answers
- 23011 Views
- Gemscab, I also Faced
- E-Mail Answers
Answer Posted / reddy
cable size can be selected like ,suppose if u have any
motor with u of 110kw and its full load current is 190 then
when it is in dol stater starting torque is high up to 2
times of that full load so we have to use 300sq mm.if it is
in star delta 240 sq mm is enough because in a star
starting current is low it means 70 to 60 percent of full
load .after that some time delay delta pick ups
| Is This Answer Correct ? | 40 Yes | 21 No |
Post New Answer View All Answers
what is vA rating and class of a ct.
On 400 amp factory load how kvarh capacitors provide
How to select the proper VSD to operate high inertial load
How does "OUT OF STEP" relay ,for Synchronous motor protection, work?
Why does the radius of armature is less than the radius of pole shoe?
how to select the isolation tranformer for siemens 802dsl cnotroller
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?
Why air circuit breaker off due to power failure?
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
what is the formula of starting current of 3phase and 1 phase motor???
What type of fittings and electrical accessories can be install in radiation area ?
i m doing DEEE in part time,can i join regular cources in BE,,IF i join what the cources can i select like (civil,ece,IT) ,,kindly advice
What is transmittance?
can anyone please help me to find the rupturing or breaking capacity in KA of circuit breaker (MCCB,VCB,ACB etc) of HT and LT side of a distribution transformer...please help with detailed step by step answer...thank you
