why the backwheel of tractor is bigger than frontwheel?
- 12 Answers
- 14609 Views
- HAL, HMT, MAHINDRA, I also Faced
- E-Mail Answers
Answer Posted / muhammad usman
because the back wheel needs to produce more and more torque
to pull more n more load........
| Is This Answer Correct ? | 16 Yes | 12 No |
Post New Answer View All Answers
please send me previous placement papers of cummins company
AFTER OVERHAULING KTA19G3 AND JUST ABOUT TO START ,BUT WE DIDNT FIX THE OIL SUMP AND TEST FOR -WATER LEAK FROM LINER O RING SIDE,THEN WE FILLED WATER AND FOUND WATER LEAK FROM INSIDE OF ENGINE -CAM FOLLOWER SIDE PLEASE GIVE ADVICE TO RECTIFY THE SAME
What are the major effects of alloying elements?
What are the different parts of impulse reaction turbine?
How can heat be applied to acrylic?
Which is the welding process you have carried out in workshop?
Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb
please msg me tecnical question of hpcl
What is torque converter?
what is the thickness tolerances up to 32 mm
how to calculate duct fittings surface area ?
How the F.W.C. system of diesel engine circulate?
what are the application or secification (temp/presure)for which IBR pipes should be used?
Explain the advantages of diesel engines?
Question for mech.engineer in dmrc
