Interested to Buy Any Domain ? << Click Here >> for more details...
thermal power station operation in general
- 11 Answers
- 34008 Views
- AJ Square Inc, Jindal, NTPC, I also Faced
- E-Mail Answers
Answer Posted / gaurav srivastava
the thermal power station is based on modified rankine
cycle, where the coal burnt in the boiler to produce the
vapour by water..In boiler water heated to supersaturated
pointed where it in imposed on turbine by a nozzle .. the
nozzle is used to produce high velocity of steam to run the
impulse turbine .. with turbine a generator is combine
which is generate the electricity ..which is transport
through by wire....bur before transformation of electricity
a step up transformer is used to step high potential of
electricity ......
| Is This Answer Correct ? | 49 Yes | 11 No |
Post New Answer View All Answers
how to design coil turns ?
1.Z transform always lies around ? a) origin b) pole c) zero d) z=1. Multiples Mcqs which is bother me can’t find answers on internet. Some help required with little explanation . Note: this is not homework or related to any test. Thanks
how we calculate electrical load on a building according to area?
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
WHAT ARE THE DISADTAGES OF SINGLE-WIRE-EARTH-RETURN SYSTEM USED FOR RURAL ELECTRIFICATION?
why magnet has north and south poles only why not east and west and why we are considering as north and south poles? why cant we consider as east and west?
WHY THE COLOR OF OUTDOOR TRANSFORMER IS BLUE ONLY???
What is a system?
1.why we are using metal oxide gapless block in lightning arrester,2.What is minimum and maximum rating of metal oxide blocks using in india
33kv substation lay out details & line to line & line to earth measurements
What are the effects of electrical faults?
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
where lt & ht capacitor used
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
I want to calculate how much capacitor we connect to maintain the unity power factor? Is there any formula? Pls give me the answer
