Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rabi
In distribution system, required voltage level is mainly
220V which can be obtained with star connected secondary
(415/√3) as there is a provision of neutral. Also the
insulation coast for the secondary will be less the voltage
level is less in secondary.
| Is This Answer Correct ? | 12 Yes | 5 No |
Post New Answer View All Answers
what maximum range of star & delta in hp or kw ?
during installation time of transformer and alternator which points we have to observed?
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
what is the meaning of osr in transformer.
how can get electrical c licence.now i am working in spining mill , transformer capacity 2750KVA. SANCTION DEMAND 2250KVA. PLEASE ADVISE ME . MY CONTACT NO 09944226823
What is the previous name of Cox's Bazar
what is different between relay and plc?
Why we cant store an ac power. If we coo store in which device we can?
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
Is it possible to obtain 480v or 550v in single phase output by giving the input to 230v to a single phase torodial type transformer without using a stepup transformer?
how we explain parallel paths armature winding?
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.
How they LT panel busbar size choose
in dc shunt motor if field winding is shorted then
