How to calculate the motor winding resistance ?
- 21 Answers
- 115391 Views
- Forbis, L&T, OEGI, VTI, I also Faced
- E-Mail Answers
Answer Posted / daher
use DC voltage source to check the resistanceof motor
winding plus multimeter
| Is This Answer Correct ? | 14 Yes | 49 No |
Post New Answer View All Answers
wat is the current produced in a 5000v megger? when the positive and negetive terminals are touched on our body get s shock?
what's the requirement of Dy11d0 connection of 3 phase transformer?what's use of it?
Can the output voltage of a rectifier be greater than the input AC voltage without the use of any voltage multiplier in the circuit??please provide the explanation too..
can indirect loading be called as phantom loading?
Ceiling Fan and Storage type water heater. Discuss
How can calculate the earthing strip of Copper/GI for rating of 30kV,discharge current 10KA Lightning arrester.
What do you understand by external characteristics of a d.c. Generator?
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
what will happen if frequency is below 50 hz?
Where should the lighting arrestor be placed in distribution lines?
what is the difference between single ratio, multiple core and multiple ratio, multiple core ? please explain.
how to calculate the magnetizing current of ct ( 800A/1A) for Relay 64
how to compute kvar in substation feeder to improve power factor and sending voltage
