Answer Posted / kuttivenu

I think The question itself little bit wrong,coz they are
asked the question HT & LT cables that means i just want to
understand whether its in Live or Dummy cables.if it is
live you cannot able to joit directly,it will happend
through transformer only by using Step up or Step
down.depends on the winding type,it can be desired.Primary
side if you can give HT[11KV],Secondary side you can get LT
[440V].

what is reverse power relay brief explanation and in b/w where it is connected

2047

---

State kirchoff current law?

1093

---

dg earth connect only in the amf panel or not why

2094

---

what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks

1900

---

What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?

2719

---

how to find out cable size if load is 2800 watts, 230 volts AC supply and load distance is 1800 meters

1610

---

what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.

1860

---

why we used ZNO in Lightning arrester.

2006

---

what will be project cost for 100 kv transformer connection under oyt scheme.

2939

---

Draw a SLD of HT distribution EB grid up to users Transformer?

6213

---

what is the most permissible winding temp when we conducting a generator load test?(condition no load)

1728

---

What is T’Q and X’Q and X’D ? and what is saturated as well as unsaturated ?

1794

---

What is the lower limit of break-down voltage of converter transformer.

1917

---

How PSV sizing being done

2336

---

What is the minimum value of hfe for the oscillations in transistorized rc phase shift oscillator?

1275

---