Interested to Buy Any Domain ? << Click Here >> for more details...
What is effect of power factor on change in voltage
- 13 Answers
- 45945 Views
- APNPDCL, apspdcl, My Home Industries, I also Faced
- E-Mail Answers
Answer Posted / badshah
Decrease in Power Factor, increases the Current flow
throught the circuit, which in turn cause more Cu.losses
(I^2*R) & Voltage Drop (I*R). It affects the supplier very
much, costing more power loss & Poor Voltage Regulation. It
also increase the Consumption cost more for the consumer.
| Is This Answer Correct ? | 73 Yes | 17 No |
Post New Answer View All Answers
how do we calculate length of starting time and repeated starting of a direct online starter?
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
Dear all i want to know SEWA Electrical Supervisor Licence test Previous Year Questions ? If any body know please send to me zohairaukllah@yahoo.com
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
(1)WHAT HAPPENS WHEN SUDDENLY LOAD GIVEN TO THE INDUCTION MOTOR ? (2)CAN WE MAKE WOOD AS MAGNET ? (3)WHAT IS THE VALUE OF MAGNETIC FLUX DENSITY IN TRANSFORMER ? (4)WHY WE ARE USING ELECTROMAGNETI NOT ELECTROSTATIC IN MACHINE ?
What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?
Transmission voltage is kept 11KV,33KV,66KV,132KV,220KV due to form factor. What happen to 400KV and 765KV transmission voltage?
What is advantages of VSCF wind electrical system?
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
what happen if the parallel generator phase angle shift by 1 degree in manual mode
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
substation+ plc system
I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.
how can get electrical "c" licence.i am complited in DEEE.PASSING YEAR OF 1993.WORKING IN PVT COCERN LT LINE.PLEASE ADVISE ME .CELL NO 9994786021
