how can calculated the rating of the 11 KV transformer?
- 6 Answers
- 10130 Views
- NBCC, I also Faced
- E-Mail Answers
Answer Posted / sheik
to measuring in full load
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
design a LV scheme for a 15 storied building?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?
what is the chiller and working principal
Explain cos(theta) and Sin(theta)
why -48 volts dc used in telecommucation
What the main causes of transient interruptions on Over-Head Distribution Lines?
What si the d/f b/w KVA & KWH, kvarh & kvar, kwh & kvar phase voltage & line voltage
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
tell me about eletrical contractor
How to calculate energy stored in an inductance?
Is it advantages of having star-delta vfd than normal star vfd , if yes why?
what is acceptance test in electrical engineering.
Give me the calculation steps to design an electromagnet to be work in 230V 50 Hz AC Supply. Also give force that is created by that electromagnet when it gets energized.
