Interested to Buy Any Domain ? << Click Here >> for more details...
why we give clock rate to DCE and not to DTE
what is the difference in the two.
- 3 Answers
- 27618 Views
- I also Faced
- E-Mail Answers
Answer Posted / naveen agrawal
Because all Cisco router are by default DTE and it is the
receiver side(RECEIVING THE CLOCK PULSE FROM DCE) of serial
cable,basically connected the router serial interface,
and DCE basically connnected the isp router end ,it is
sender side(sending the clock pulse to DTE) of serial cable
and 2 DTE Cannot communicate directly atleast one DCE would
be there for communication
| Is This Answer Correct ? | 10 Yes | 18 No |
Post New Answer View All Answers
Explain what are the ranges of private ips?
what is prefix list
Explain types of communication in ipv4?
Name the command we give on privilege mode for coming back to user execution mode?
How arp brings mac address for switch?
What is an autonomous system?
What are the advantages of layered model in networking industry?
what is the matric of EIGRP protocol?
How can you assign a vlan to a switch port?
What is the function of a router?
What is the igp (interior gateway protocol)?
What is the checksum?
What are packets?
What do you understand by poe (power over ethernet)?
How many valid ip will b in /21 in route summarization?
